Thank you for downloading Service Pack 1 for Autodesk Robot Structural Analysis 2013 & Autodesk Robot Structural Analysis Professional 2013.

This readme contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your licensed copy of the product.

This update is for the following Autodesk products running on all supported operating systems. Be sure to install the correct update for your software.
(Live Update service recognizes downloads and installs the right update automatically).

32-bit Products	Update
Autodesk Robot Structural Analysis 2013	RSA2013_X86_SP1.exe
Autodesk Robot Structural Analysis Professional 2013	RSAPRO2013_X86_SP1.exe

64-bit Products	Update
Autodesk Robot Structural Analysis 2013	RSA2013_X64_SP1.exe
Autodesk Robot Structural Analysis Professional 2013	RSAPRO2013_X64_SP1.exe

Astro A50 Gen 4 Firmware Link -

Initiate Flash:

Wait: The software will first update the Base Station. Once complete, it will prompt you to place the headset on the cradle to update the headset firmware.

The official gateway to the Astro A50 Gen 4 firmware is the Astro Command Center software. This program detects your hardware and automatically fetches the correct firmware from Logitech’s servers.

Here are the official download links for the Astro Command Center:

If the firmware gets corrupted mid-update, your base station enters recovery mode. astro a50 gen 4 firmware link

Once you have installed the Astro Command Center (the real link for the firmware updater), follow this guide:

Step 1: Physical Connection

Step 2: Launch Astro Command Center

Step 3: Check for Update

Step 4: The "Manual Recovery" Trick (For stubborn Gen 4 units) If the software says "No update" but your headset is glitching, you may need to force a recovery:

Who Should Install This Update?

Astro A50 Gen 4 Firmware Link -