Aukey Pby37 Manual File

Port Selection Advice:

Cause: The PBY37 has over-discharge protection. If the battery drains to 0%, it enters a “sleep” state. Fix: This is the most critical tip in the Aukey PBY37 manual. Leave the power bank plugged into a wall charger for at least 30 minutes (even if no LEDs turn on). It can take up to 20 minutes for the charging circuit to “wake up” from deep sleep.

This is the most referenced section of any Aukey PBY37 manual. Next to the power button, there are 4 small white LEDs. aukey pby37 manual

The PBY37 is unique because it has two ways to get power in. Your physical manual likely shows a diagram of this.

Method A: Micro-USB Input

Method B: USB-C Input

Important Note from the Manual: Do not plug a USB-C to USB-C cable into the PBY37’s input port if the other end is connected to a laptop. The PBY37’s USB-C port is input only. It will not charge a laptop or act as a USB-C output. Port Selection Advice: Cause: The PBY37 has over-discharge

While charging:

Sometimes Aukey prints a QR code on the back of the power bank or the box that links directly to the PDF manual. Method B: USB-C Input

| Button / Feature | What it does | |----------------|--------------| | Power button | Short press → check battery level (LEDs) | | Double press | Turn off output (some models) | | Long press (2-3 sec) | Enter low-current mode (for earbuds/smartwatches) | | USB-C port | Input (charging the power bank) + output (charging devices) | | USB-A ports | Output only | | LED indicators | 4 LEDs = ~25%, 50%, 75%, 100% charge remaining |