Epson Et 2400 Reset Install Review

Once the reset is complete, you must treat the printer as if it is brand new.

Do not plug the USB cable in yet (unless the software prompts you).

If the button press doesn’t work, use the official Epson Firmware Updater or Maintenance Tool. epson et 2400 reset install

Note: If your printer shows “Ink low” but the tank is physically full, do not use third-party resetter tools. They often break the ink flow sensor.

If the printer is out of warranty and bricked, a used mainboard from eBay ($30-50) can restore functionality. After replacement, you must run the “Initial Fill” process again from scratch. Once the reset is complete, you must treat

  • Issue: Printer says “No ink” despite full tanks.

    • The ET-2400 does not use traditional cartridges with chips. Instead, it uses a transparent tank. The printer tracks ink usage via a virtual counter. When you refill the tank, the printer does not automatically know you added ink. You must trigger a reset.

    Warning: This procedure addresses the "Ink Pad Counter" error. The ET-2400 is classified as a " locked" model by Epson, meaning standard third-party reset tools (like older WIC Tools) may not function without a Key. Note: If your printer shows “Ink low” but

    Prerequisite: Before resetting, ensure waste ink is physically managed. If the ink pads are full, resetting the counter without replacing them will cause ink to leak inside the printer.

    Procedure:

  • Enter Service Mode:
  • Run the Utility: