Extra Quality Inurl Multicameraframe Mode Motion Official

Even with the correct inurl: access, users fail to achieve "extra quality" due to these pitfalls:

Mistake 1: UDP vs. TCP If you see pixelation in multicameraframe mode, your protocol is wrong. Force TCP in the RTSP URL:
rtsp://admin:pass@ip:554/cam/realstream?proto=TCP&quality=extra extra quality inurl multicameraframe mode motion

Mistake 2: Sub-stream Leakage Many NVRs show the sub-stream (low resolution) in multicamera view and only switch to main stream on full screen. Force the NVR to load the main stream in every cell of the frame. Look for force_mainstream=1 in the URL parameters. Even with the correct inurl: access, users fail

Mistake 3: Motion Blur from Shutter Speed "Extra quality" fails if the shutter speed is too slow. In your camera's inurl:config page, set Minimum Shutter to 1/250 (for indoor) or 1/1000 (for outdoor fast motion). Force the NVR to load the main stream

To achieve "multicameraframe mode motion," you need to configure your Video Management System (VMS) to automatically switch display modes based on triggers.

A single camera at extra quality motion mode (4K, 60fps, H.265) consumes ~25GB per day only when motion occurs. For an 8-camera frame, use a Purge Policy: Keep last 7 days of full quality, then re-encode to standard.