⚠️ Warning: Always consult the official Intelilite AMF 25 manual before performing a hardware reset.
This guide covers the default credentials for standard InteliLite and DSE AMF controllers (commonly used in genset automation).
Once you gain access to the controller, immediately change the default passwords to a secure, unique code.
Disclaimer: This information is for educational purposes and intended to assist owners in configuring their equipment. Always refer to the official operation manual provided with your specific genset controller model.
The default password for the ComAp InteliLite AMF 25 controller depends on the specific hardware generation and firmware version you are using. Because these controllers are used in critical power applications, manufacturers have updated security protocols over time. Default Passwords by Controller Generation Controller Model / Generation Default Username Default Password / PIN InteliLite NT AMF 25 (Older) 0 or 1 InteliLite AMF 25 (v3) 0001 (UserID) 0000 InteliLite 4 AMF 25 (Latest) administrator Serial Number (SN) How to Log In
On-Device Access: Navigate to the "Password" or "EnterPassword" setpoint group using the Up and Down arrows on the front panel.
Software Access: If connecting via a PC tool like InteliConfig or LiteEdit, you will typically be prompted for credentials upon connection.
Entering the Code: For older models, use the Up/Down buttons to change individual digits and Enter to confirm. Troubleshooting a Lost Password
If the default passwords do not work, the password has likely been changed by a previous technician. To recover access: How to reset password in a ComAp controller
If 1234 does not grant access to the settings menu, the controller has likely been re-programmed by the generator manufacturer or a previous technician. DSE controllers allow users to change these defaults for security purposes.
Recovery Options:
| Parameter | Value |
|-----------|-------|
| Default Username | comap |
| Default Password | comap |
Note: The controller uses a numeric keypad for local entry. The password
comapis entered as26627using the telephone keypad mapping (C=2, O=6, M=6, A=2, P=7).
Restrict physical access to RS232/USB ports (e.g., lockable enclosures).
Isolate management interfaces from untrusted networks:
Implement role-based access control if using ComAp WebSupervisor or SCADA front-ends.
Regular audits:
Firmware updates:
A: The password has been changed. Use the hardware reset procedure above or contact your local generator service company.
