Manual Kingtex Sh 6000 Series Hit Verified ◆

Step 1: Enter Service Mode Power off the machine. Hold the P (Program) and + buttons simultaneously while turning the power on. The screen will flash S.ErV.

Step 2: Select Hit Sensor Test Using the arrow keys, navigate to parameter H-09. This is the “Needle Encoder Verification” menu. Press Enter. manual kingtex sh 6000 series hit verified

Step 3: Manual Crank Slowly turn the handwheel toward you. Watch the LED bar on the control box. When the needle is exactly 3mm above the needle plate, you should hear a beep. This is the “Hit Ready” position. Step 1: Enter Service Mode Power off the machine

Step 4: Set Verification Window In the manual, you will find a chart titled “Verification Window Tolerance.” Set parameter H-10 to 085 (default for standard fabric) or 092 (for heavy denim). This tells the machine how many micro-degrees of rotation count as a “verified hit.” Did you know you can adjust the verification strictness

Step 5: The Dry Run Test Remove the thread and fabric. Run the machine at 500 RPM. The display must show HIT UER (Hit Verified) continuously. If you see HIT FALL (Hit Failed), repeat step 4.

---

Did you know you can adjust the verification strictness? The manual’s “Hit Verified” section (page 52) reveals advanced parameters for power users.

Kingtex recommends an annual “Hit Verification Certification” performed by an authorized technician. They will run a 10,000-stitch validation test and issue a printed certificate. This is mandatory for ISO 9001:2024 textile compliance.

---