Multibeast 11.3.0 - — Mojave

When you open the application, you will see a simplified interface compared to older versions. Here is the typical workflow for a Mojave build:

Cause: Mojave resets the audio layout ID after sleep. Fix: Re-run MultiBeast, but this time go to Customize > Audio and manually type your layout (e.g., 1, 2, 5, 7, 11). For ALC1220, use layout-id = 11. You can verify with Hackintool. multibeast 11.3.0 - mojave

For the uninitiated, MultiBeast is an all-in-one post-installation utility developed by tonymacx86. It is designed to simplify the process of installing bootloaders, drivers (kexts), and system patches on a new Hackintosh installation. When you open the application, you will see

Think of it this way: You’ve just used UniBeast or a manual OpenCore guide to install macOS Mojave onto a vanilla PC. At this point, your audio probably doesn’t work, your network drivers are missing, and your graphics acceleration is choppy. MultiBeast automates the repair of these issues. The "Drivers" tab is where you fix hardware

MultiBeast 11.3.0 is the specific iteration built exclusively for macOS 10.14.6 (the final, most stable version of Mojave). Earlier versions of MultiBeast (e.g., 10.x) were designed for High Sierra, while later versions (12.x) target Catalina and Big Sur.

---

The "Drivers" tab is where you fix hardware. For Mojave, focus on these sub-sections:

When you launch MultiBeast, the interface is divided into four main sections: Quick Start, Drivers, Bootloaders, and Customize. Here is how to navigate each for a Mojave build.