Nitocote Nt402 Msds Now

| Property | Value | |----------|-------| | Appearance | Viscous liquid | | Odor | Slight amine-like (Part B) | | pH (mixed) | ~9–10 (alkaline) | | Viscosity (mixed) | 750–1000 cP | | Density | ~1.10–1.20 g/cm³ | | Solubility in water | Miscible (water-based system) | | VOC content | <50 g/L (low VOC) |

| Exposure Route | Immediate Action | |----------------|------------------| | Inhalation | Remove to fresh air. If breathing difficulty, give oxygen. | | Skin contact | Wash immediately with soap & water. Remove contaminated clothing. For allergic reactions, seek medical attention. | | Eye contact | Rinse cautiously with water for ≥15 minutes. Remove contact lenses. Immediate medical attention required (especially for Part B). | | Ingestion | Do NOT induce vomiting. Rinse mouth. Seek medical help immediately. | nitocote nt402 msds

This is the section most frequently consulted by safety officers. | Property | Value | |----------|-------| | Appearance

| Exposure Route | Control Measure | Recommended PPE | | :--- | :--- | :--- | | Inhalation | Local exhaust ventilation (LEV) | Half-face or full-face respirator with Organic Vapor (OV) cartridges (e.g., NIOSH approved 6001). | | Skin (Hands) | Chemical barrier | Nitrile gloves (0.4mm thickness, >480 min breakthrough time). Do not use latex or neoprene – they degrade quickly with aromatics. | | Skin (Body) | Avoid splashes | Tyvek or chemical-resistant apron. | | Eyes | Splash guard | Chemical splash goggles (not just safety glasses). | | Footwear | Spill resistance | Rubber boots with steel toe (leather absorbs solvent). | Remove contaminated clothing

Occupational Exposure Limits (OELs): For Xylene, the typical 8-hour TWA (Time Weighted Average) is 100 ppm (435 mg/m³) ACGIH. The MSDS will state that users should stay below these limits.