| Step | Action | Note | |------|--------|------| | 1 | Preheat both nozzles to 200°C | Prevents ooze during leveling | | 2 | Home all axes (via LCD menu) | Wait for full stop | | 3 | Disable steppers | Manually move print head | | 4 | Paper test at 4 corners + center | Slight drag on A4 paper | | 5 | Set Z-offset (if using auto-level probe) | Only on newer X-Pro models |
The manual says "possible," but doesn't detail: qidi x-pro manual
Even the best manual has blind spots. Here are the top three issues users face that are not adequately explained in the original text. | Step | Action | Note | |------|--------|------|
The physical manual comes with a separate "Software Quick Start" guide for QIDI Slicer (a customized version of Cura). Instead of dual extrusion, you can use a
Instead of dual extrusion, you can use a single nozzle and print "Breakaway" supports. Go to Slicer > Support > Enable Support Interface. This creates a dense layer that snaps off cleanly.
Manual Mistake Alert: The original manual states the offset should be "around 32mm." In reality, due to manufacturing tolerances, your offset could be between 31.8mm and 32.4mm. Trust your measurement, not the manual's assumption.