Kada prvi put otvorite Tower 7, vidite sledeće ključne module:

Napomena: Prema većini Radimpex Tower 7 uputstvo preporukama, poželjno je prvo podesiti jedinice mere (kN, m, cm) u meniju Opcije > Podešavanje jedinica.

| Problem | Likely Solution | |--------|----------------| | Model won’t analyze | Check for unconnected nodes, duplicate elements | | No results on some elements | Run analysis again; check if they have section & material | | Slab doesn’t transfer load | Ensure slab is defined as a surface element (not just visual) | | Wind load missing | Use manual pressures or define as uniform on vertical surfaces | | Reinforcement appears too high | Increase cross-section or check load combination factors |

Tower 7 is a 3D FEM structural analysis and design program, primarily for:

Modules (typical):

The standard workflow in Tower 7 follows a logical progression. Here is a summarized instruction set for a typical project:

Iako je ovaj vodič kompletan, ponekad vam je potrebna specifična informacija.