Telemecanique Tsx 17 Programming Software May 2026
The TSX 17 series belongs to the "Telemecanique Series 7" family. It is crucial to distinguish the TSX 17 from the newer TSX 37 or TSX 57 (Unity) platforms.
Primary Programming Software:
Note on Compatibility:
If you want, I can:
Telemecanique TSX 17 is a legacy micro-PLC range that primarily uses telemecanique tsx 17 programming software
software for programming. Because this system is discontinued, current support and software are primarily maintained through the Schneider Electric Support FAQ Software Versions
The appropriate software depends on the specific hardware model and whether a language cartridge is installed: Control.com PL7-1 (Part No. TSXLPL71V5E): models. It supports Instruction List (IL) language and simple single-task structures. PL7-2 (Part No. TSXLPL72V5E): units equipped with a PL7-2 language cartridge . It adds support for Ladder (LD) (Sequential Function Chart) programming. Combined Package (Part No. TSXLPL712V5E): A legacy bundle that supports both PL7-1 and PL7-2. Schneider Electric System Requirements & Connectivity Operating System: These packages are
. They are officially unsupported on Windows 2000, XP, or newer versions. Running them typically requires a dedicated DOS machine or a DOS emulator (like DOSBox). Programming Cable: You must use the TSX17ACCPC
cable to connect the PLC to a computer's serial port. An RS232/485 converter may be necessary depending on your PC's hardware. Hardware Cartridges: The TSX 17-20 requires a specific module (e.g., TSX P1720FA The TSX 17 series belongs to the "Telemecanique
) to unlock PL7-2 capabilities. Programs can also be stored on EEPROM/EPROM cartridges for backup. Schneider Electric Legacy Support Resources
Detailed technical characteristics and installation procedures are available via the TSX 17 Micro-PLC Installation Manual Troubleshooting:
Diagnostic LEDs on the unit (RUN/STOP, CPU/PROG, IO/MEM, BATT) indicate the PLC's state; a blinking RUN/STOP LED usually means the program is intact but the PLC is stopped. MRO Electric Are you looking to extract a program from an existing unit or develop a new application for a TSX 17 system? For PLC range TSX17 , Can I make a backup of the software?
Here’s an interesting story about the Telemecanique TSX 17 programming software — not just a technical tale, but one wrapped in mystery, industrial archaeology, and a little bit of retro-digital obsession. Note on Compatibility: If you want, I can:
If your factory still has a TSX 17 running a critical machine, you have four options:
The software is useless without a physical connection. Here is the anatomy of a working connection.
Hardware Required:
Connection Protocol (PL7-17 for Windows):
Troubleshooting "No Response" errors:
If the original program source (the .PRJ or .STA files on a PC) is lost: