Woodzig Model 40268 Manual Updated May 2026
The original Woodzig Model 40268 manual suggested lubricating every 50 hours. The updated manual changes this to a condition-based schedule due to modern synthetic greases lasting longer.
Following three reported incidents of unintended blade coasting, Woodzig has extended the brake engagement delay from 1.2 to 1.8 seconds. The new manual provides a revised wiring schematic for retrofitting older 40268 units with the updated safety relay (Part #WZ-RLY-402). woodzig model 40268 manual updated
The most valuable part of the Woodzig Model 40268 manual updated is the expanded error code table. Here are the top five codes users encounter: Revision: 2024 Update
| Code | Meaning (Old Manual) | Meaning (Updated Manual) | Solution | | :--- | :--- | :--- | :--- | | E-01 | Overcurrent | Phase imbalance on input | Check wall outlet voltage. Requires 220V ±10%. Use a multimeter. | | E-07 | Sensor fail | Hall effect sensor gap >2mm | Remove the side cover. Push the sensor bracket toward the magnetic ring until gap is 1.2mm. | | E-12 | Temp high | Motor winding >130°C | Stop for 45 minutes. Do not just reset; clean the cooling fins. | | E-19 | Brake error | DC injection voltage low | Replace the bridge rectifier (Part #40268-19). Do not run until replaced. | | F-03 | (Not listed) | Feed roller slip | Increase pressure spring tension to setting #4. | A: No
Pro Tip: If you see "E-07" repeatedly, the updated manual suggests replacing the sensor magnet, not the sensor itself.
Revision: 2024 Update
A: No. The 2023 Model 40268 has a different control board and a revised belt tensioner. Using the old manual for calibration will result in poor surface finish and potential code F-03 errors.
